www.eaton.com IL02601010E V.1.01 Q-1DIN Rail InstallationIQ 100 Series Transducer Quick Start GuideMechanical InstallationQ Installation StepsSlide top of groove ofmeter onto DIN Rail.Press gently until themeter clicks into place.If mounting with DINRail provided, use BlackRubber Stoppers (alsoprovided) shown below.To remove meter, pulldown on Release Clip.Electrical Wiring DiagramsIQ 100 Series Transducer DimensionsWYE Direct 3 Phase, 4-wire WYE with PTs 3 Phase, 4-wireDELTA Direct 3 Phase, 3-wire DELTA with PTs 3 Phase, 3-wireSelect a diagram to meet yourapplication.NOTE: Other wiringconfigurations are available.See the IQ 100 Series Userand Installation Manual, onthe enclosed CD.Release ClipHIGH SideLOW Side

Eaton IQ 100 Series Quick Start Manual

Disclaimer of Warranties and Limitation of Liability

Support Services

Technical Resource Center

IQ 100 Series Meter Overview and Specifications

Current Inputs

Specifications

IQ 100 Series Mechanical Installation

ANSI Installation Steps

DIN Installation Steps

IQ 100 Series Transducer Installation

IQ 100 Series Electrical Installation

CT Leads Terminated to Meter

CT Leads Pass-Through (No Meter Termination)

Quick Connect Crimp CT Terminations

Voltage and Power Supply Connections

Electrical Connection Diagrams

Service: 2.5 Element WYE, 4-Wire with No PTs, 3 CTs

Service: WYE, 4-Wire with 3 PTs, 3 CTs

Service: 2.5 Element WYE, 4-Wire with 2 PTs, 3 CTs

Service: Delta, 3-Wire with No PTs, 2 CTs

Service: Delta, 3-Wire with 2 PTs, 2 CTs

Service: Delta, 3-Wire with 2 PTs, 3 CTs

Service: Current Only Measurement (Three Phase)

Service: Current Only Measurement (Dual Phase)

Service: Current Only Measurement (Single Phase)

IQ 100 Series Communication Installation

For All RS485 Connections

IQ 100 Series Transducer Communication Information

Programming the IQ 100 Series Meter Using the Front Panel

Using the Front Panel

Using the Main Menu

Entering a Password

Using Configuration Mode

Configuring the Scroll Feature

Configuring CT Setting

Configuring PT Setting

Configuring Connection Setting

Using Operating Mode

Understanding the % of Load Bar

Performing Watt-Hour Accuracy Testing (Verification)

Programming the IQ 100 Series Meter Using Software

Accessing the IQ 100 Series Device Profile

Performing Device Profile Tasks

Configuring Settings

Configuring Energy and Display Settings

Configuring Communication Settings

Polling the IQ 100 Series Meter

Poll Power and Demand

Poll Phasors

Using the IQ 100 Series Tools Menu

Performing Additional Tasks with Eaton Meter Configuration Software

Disconnecting from an IQ 100 Series meter

Using the Options Screen

App. A: IQ 100 Series Navigation Maps

App.B Modbus Mapping for IQ 100 Series

Floating Point Values

Important Note Concerning the IQ 100 Series Modbus Map

IQ 100 series