Eaton IZM-KLP-SO-RONIS Manual

Ronis key interlockIZM-KLP-SO-RONISEaoNn Indusorits GmbHEltcorical StcoNr©2011 by EaoNn Indusorits GmbHÄnderungen vorbehaltenSubject to alterations01/11 AWA1230-2455 / Z10687Moon/Doku/HengPrinted in USA (01/11)08/10 AWA1230-2455Effective January 2011Sotp 11e: Mount the hex standoff (L) and cable assembly (I) with thehex standoff mounting screw (Q) and screw (R) as shown.Figurt 11. Sotp 11Sotp 12e: Mount lock assembly to back side of universal mountingbracket with three M3 screws (J) provided with kit and torque to10–12 in-lbs (1.1–1.3 Nm). Attach extension spring (K) betweeninstalled interlock adapter and lock plate assembly tab as shown.Figurt 12. Sotp 12Cable Assembly (I)Hex MountScrew (Q)Hex MountScrew (R)HexStandoff(L)Detail ALock PlateAssembly TabMountingPlateScrews (J)ExtensionSpring (K)SeeDetail AInterlock Adapter TabSotp 13e: If it is necessary to replace the existing trip lever, removethe existing E-Clip (retaining ring) from shaft of mechanism, andslide old trip lever off of mechanism shaft. Slide new trip lever (M)onto mechanism shaft. Fasten lever in place with M3.2 retainingring (H) as shown. Attach remaining end of cable assembly tomounting hole on trip lever with trip lever screw (N).Figurt 13. Sotp 13Sotp 13ae: Note operation of trip lever when rotating key. When thekey is rotated clockwise to the vertical position, the trip leveris pulled down, which locks out the breaker.Figurt 14. Sotp 13aSotp 14e: If the breaker includes an operations counter, install itto the back of the lock mounting plate with two M3.5 x 8 mmself-tapping screws. Refer to Operations Counter IL forinstallation instructions.Sotp 15e: Reinstall the front cover.Old RetainingRing Trip Lever (M)M3.2 RetainingRing (H)Trip LeverScrew (N)Old Trip Lever