Eaton MBP6Ki Installation And User Manual

Also see for MBP11Ki: Installation and user manual

Contents

Page 15SK-90510-Y4_ENENGLISH5. OperationsUPS BYPASSUPS BYPASS5.1 UPS start-up with HotSwap MBPVerify that the total equipment ratings do not exceed the UPS capacity to prevent an overload alarm.1. Check that the UPS is correctly connected to the HotSwap MBP (see previous chapter 4)If the UPS if equipped with outlets, those outlets can no longer be used (loads can only be connected to theMBP outlets or the MBP Output terminal blocks).2. Verify that the MBP terminal blocks are connected to the AC source, and to the Bypass AC source (*)3. Check that the MBP manual Bypass switch is to the "Bypass" position4. Set the upstream circuit breaker (not provided) to the "I" position (On) to switch On the utility power, andalso set the Bypass source upstream circuit breaker (not provided) to the "I" position (On) to switch on theBypass power (*)5. Verify that the “Bypass mode”red light of the MBP goes On, indicating that the load is now poweredby the AC source, or Bypass AC source (*)6. Set the Normal AC source switch and the Bypass AC source switch (*) of the MBP to the "I" position7. Verify that the UPS is correctly powered (UPS display panel illuminates)8. Press the UPS “ON” button to start the UPS9. Put the UPS in “internal Bypass mode” (refer to the UPS User Manual)10. Verify that the UPS is on Bypass mode by checking UPS display panel (refer to the UPS user manual)11. Verify that the “UPS mode” green light of the MBP goes On, indicating that the UPS output power isavailable on the MBPImportant: do not continue to next step if the "UPS mode" green light of the MBP is still Off(the load will be lost)12. Set the MBP manual Bypass switch to the "UPS" position: the "Bypass mode" red light of the MBP goesOff, indicating that the load is now powered by the UPS13. Put the UPS in "normal mode" (refer to the UPS User Manual)14. Check that the UPS is in Online mode by checking UPS display panel (refer to the UPS user manual)the load is now protected by the UPS(*) only in case of Bypass AC source option connected (MBP11Ki and MBP11Ki31 only).