Eaton MEM Memera Manual

Eaton Electric LimitedReddings LaneBirmingham B11 3EZUnited KingdomCustomer Support CentreUK tel: +44(0) 8700 545 333UK fax: +44(0) 8700 540 333email: ukcommorders@eaton.comwww.eaton.com© 2009 Eaton CorporationAll Rights ReservedPrinted in UKForm No. IL01900001UMarch 2009PowerChain Management is a registeredtrademark of Eaton Corporation.All other trademarks are property of theirrespective owners.Remove the main outer cover from theEATON MEMERA CONSUMER UNIT1. Remove the Busbar from the transit holder.2. Fix the back plate to the wall using the keyhole FixingsCAUTION: DO NOT BEND & RE-STRAIGHTEN THE BUSBARWhen fitting the Busbar into the isolator ensure that the flexiblelive connector is fitted beneath the busbar in the box clamp.Fit the busbar Shield into the base andover the unprotected Busbar.Fit the busbar Shield into the base andover the unprotected Busbar.Remove the appropriate “Knockouts” for cable entry.Cut the Busbar to the desired length (number of waysplus one tongue) the raised “Dog leg portion of thebusbar must be fitted to the Main Switch. Ensure the fullportion between tongues is removed and discarded.CABLE CAPACITY AND TORQUE SETTINGSCABLE CAPACITYISOLATOR 2.5Nm 50mm2RCD/RCBO 2.5Nm 25mm 2OTHERS 2.0Nm 25mm 2Fit the Busbar/s: Ensure all terminals are fully open before installingthe busbar, tighten all connections to the specified torques.Apply the Instruction Label & RCD resetting instructions(where applicable) to the inside of the door.Affi x the required main circuit identification labels& Sub circuit identification for RCD protectedcircuits, for split loads cut as required.Warning – Intellectual Property RightsEaton wishes to make it clear that it owns intellectual property rights in the productwhich it manufactures (whether or not listed in this leafl et) and that it will take legalaction against any party found to be manufacturing, using, or selling any article whichinfringes the company’s intellectual property. All marks in this document identifi edwith an R symbol or a TM symbol adjacent to the mark are trademarks of Eaton.The use to which this product is put and its place of installation is outside our control.Particular care should therefore be taken to follow the instructions given here andto ensure their continued availability in conjunction with the use of the product.No responsibility can be accepted by us if these instructions are disregarded. Furthercopies of these instructions and information concerning the installation and proper useof this product can be obtained by contacting the: Technical Services Department

/ 2

Related manuals for Eaton MEM Memera