Eaton MEMSHIELD3 Instruction Leaflet

IMPORTANT NOTES1. This product should be installed, commissioned andmaintained by or under the supervision of a competentelectrician in accordance w ith current electrical engineeringCodes of Practice, Regulations for the Electrical equipmentof Buildings (BS7671), CDM2007 - Construction (Designand Management) Regulations 2007, HSG150 - Health andSafety in Construction, Statutory requirements and anySpecific instruction issued by the Company.2. After completing the installation and testing of this product itis essential that this leaflet is draw n to the attention of theperson responsible for its future operation and maintenance,and is at all times available for ready reference.3. These notes assume throughout that the product isdisconnected from the supply. It is essential that this is donebefore any w ork is carried out.4. When carrying out insulation resistance testing, ensure themeter voltage fuses are removed.MEMSHIELD 3 SMARTMETER SPLIT LOAD DISTRIBUTION BOARDInstruction leaflet LT1184 (03/21)Drawn asEBMSL642MPMBkWhWMeter operating instructions canbe found on leaflet provided withdigital meter.Please ensure that meterinstructions are available forcontinued use of the product.METERLOAD 2LOAD 1These Distribution Boards are designed only foruse w ith MCB’s and RCBO’s as listed in the currentMem shield 3 catalogue.Failure to com plyw illresult in invalid w arranty andcertification.CAUTIONDo not fit SP & SN, or 4 pole MCB’s in TPtype B boardEnsure both neutralshields are fittedafter installationTighten to15NmEarth boltTighten to15Nm

/ 4

Related manuals for Eaton MEMSHIELD3