Eaton MTL83*C Modbus Software Manual
Also see for Crouse-hinds series: Operating instructionsInstruction manualOperating instructionsOperating instructionsInstruction manual
                                    | |
Contents
| 
2INM MTL83xC PC Modbus Rev 1DRAFT - 06 January 20192 QUICKSTART GUIDEThis quickstart guide is written for an MTL83xC system based on an MTL831Ctemperature input multiplexer transmitter with an MTL838C multiplexer receiver.Before the actual installation, it is recommended that new users initially set up asimple system on the bench to become familiar with the MTL83xC system. Theminimum hardware required for a test system is as follows:MTL831C Analog transmitterMTL838C ReceiverMTL5553 Isolator (for hazardous area installations only).In order to run a test the following equipment will be required:A PC loaded with MTL83xC Configuration software, Power supply 20 - 35V @500mA, together with suitable cabling for the following requirements:Data highway connections (see INM831C / INM838C)Power supply connectionsUSB cableThe user will also need the following documentation for wiring information:INM831C MTL831C installation manualINM838C MTL838C installation manualConnect at least one sensor to an MTL831C.Refer to chapter 5 to configure and test the system. |
Related manuals for Eaton Crouse-hinds series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine