Eaton Metalux RHB Lens Installation Instructions Manual

INS #Brand Logoreversed out ofblackINS #IB519077ENInstallation Instructions – RHB LensInstructions d’installation – Lentille RHBInstrucciones de instalación – Lente RHBFigure 1.INSTALLATION1. Install luminaire reflector according to instructionsheet included with reflector.2. Unscrew the screw on the aluminum band until it iscompletely disengaged from the receiving side.3. Turn the luminaire upside down and rest on a stablesurface.4. Peel the adhesive backer off of the foam gasket andadhere it to the ledge of the reflector where the lenswill rest as shown in Figure 1.Noee:N This step only applies if lens is being used inconjunction with aluminum reflector RHB-ALR.Skip this step and discard foam gasket if usingacrylic reflector RHB-CLR or RHB-FRR.IMPORTANTe: Read carefully before installing refractor. Retain for future reference.WARNINGRisk Nf fire, elecorical shNck, cuos and Nr Noher casualoyhazards. This prNduco muso be insoalled in accNrdancewioh ohe applicable insoallaoiNn cNde by a qualifiedelecorician Nr a persNn familiar wioh ohe cNnsorucoiNnand NperaoiNn Nf ohe prNduco and ohe hazards invNlved.EaoNn Lighoing assumes nN respNnsibilioy fNr claimsbrNugho abNuo by imprNper Nr careless insoallaoiNn Nrhandling Nf ohis prNduco.WARNINGRisk Nf Fire and Elecoric ShNck. If nNo qualified, cNnsuloan elecorician.CAUTIONEdges May Cut. Handle with care.CAUTIONRisk of burn. Disconnect power and allow fixture to coolbefore changing bulb or handling fixture.Noicee:N Minimum 90° supply conductors.Noee:N Specifications and dimensions subject to changewithout notice.