3. INSTALLATION• Use the provided MAC address label to identify the card.• Connect the ETHERNET cable.• Check the ETHERNET port indications.• Wait until the Data LED flashes regularly (approx. three minutes), indicating that card start-up has terminated correctly.Note: You can set the parameters via Service port even if the network is not connected. At connection, the card will restart keeping the settings.4. IP SETTINGSOnce the card has started, proceed as indicated below:• Connect the serial cable to card’s service port and PC’s COM port (shipped with the card)• Use a terminal emulator such as PuTTY with these settings:"Echo typed characters locally" option: disabled• Type admin.The main configuration menu is displayed:Your network is equipped with a BOOTP/DHCP server (default)The card is configured by default with this service enabled. No manual configuration is required. The IP parameters areautomatically collected by the card.From the main configuration menu: (see above)• Press the 2 key (Network configuration).• Press the 1 key (Read Network settings).The settings supplied by the server are displayed:• Note the IP address.• Press the 0 key (Exit).Press the 0 key (Exit).-------------------------------------------------------------------------------------EATON NETWORK MANAGEMENT CARD-------------------------------------------------------------------------------------1 : Reset2 : Network configuration3 : Set Login Password to Default4 : Return to Default Configuration0 : ExitNetwork configuration :MAC address : 00:20:85:FD:1C:07Mode : DHCPIP address : xxx.xxx.xxx.18Subnet mask : 255.255.248.0Gateway : xxx.xxx.xxx.11 : Read Network settings2 : Modify Network settings3 : Set ethernet speed0 : ExitFor each of the following questions, you can press "Return" to select the valueshown in braces, or you can enter a new value.Should this target obtain IP settings from the network?[N] NStatic IP address [192.168.1.2]?192.168.1.82Subnet mask IP address [255.255.0.0]? 255.255.255.0Gateway address IP address [0.0.0.0]? 192.168.1.1DoneBits per second Data bits Stop bits Parity Flow control9600 8 1 None NoneYour network is not equipped with a BOOTP/DHCP server (manual configuration is required)To set the network configuration, use terminal emulation (see above)From the main configuration menu:• Press the 2 key (Network configuration).• Press the 2 key (Modify Network settings).• Follow the instructions and enter the IP parameters:Wait until "Done" is displayed, indicating that the IP parameters have been saved.• Press the 0 key (Exit).• Press the 1 key (Reset).• Press the 2 key (Restart).The card restarts with the new IP settings (after approx. one minute).5. ACCESS TO SUPERVISIONTo check whether the Network Card-MS is operational after installation and IP settings, please proceed as follows.• Run a browser• Enter in the address bar: http://IP address/ (e.g. http://192.168.1.82)• The home page is displayed• Set the time by clicking the Settings >> Time command.• Continue configuration via the sections in the Settings menu.