Eaton Power Xpert 1000 Series User Manual

Also see for POW-R-COMMAND 1000: Instructions for the Use, Operation and Maintenance Instructions for the Use, Operation and Maintenance Quick start guide User guide Installation and user manual

Contents

GETTING STARTEDEATON Power Xpert® Gateway Series 1000 Card User's Guide 164201670 Rev 4 www.eaton.com/powerquality 158. If you connected Ethernet Port 2 to a separate network, continue toStep 9 to assign the IP address for Port 2. Otherwise, continue toStep 11.9. Type 2 and press Enter on the Network Settings menu (seeFigure 13) to display the Network Settings: Ethernet Port 2 menu(see Figure 14).---------------------------------------------------------------------------- Network Settings: Ethernet Port 2 ----------------------------------------------------------------------------1. Dynamic Addressing (DHCP) : Enabled2. IP Address : [None]3. Subnet Mask : [None]4. Default Gateway : [None]5. Media Type : [Auto-negotiate]MAC Address : 00:60:26:10:89:A8Link Status : Enabled0. Exit to previous menuSelect an option ==>Figure 14. Ethernet Port 2 Menu10. Repeat Steps 2 through 7 to assign the IP address and otheroptions for Port 2.11. If you will be using host names for controlling access to the card,type 3 and press Enter on the Network Settings menu (seeFigure 15). Type the primary DNS server IP address and press Enter.Type 4 and press Enter. Type the secondary DNS server IP addressand press Enter.------------------------------------------------------------------------- Network Settings -------------------------------------------------------------------------1. Ethernet Port 1 Settings2. Ethernet Port 2 Settings3. DNS Server (Primary) : 10.222.51.84. DNS Server (Secondary) : [None]5. Reset to Factory Defaults and Exit6. Save & apply all settings0. Exit without savingSelect an option ==> 4Figure 15. DNS Server Settings