Eaton Power Xpert User Manual

Also see for Power Xpert Meter 2000: Quick start guide Quick start guide Instructions Quick start guide

Contents

Operation and MaintenanceEaton Power Xpert Gateway PXGX UPS Card User’s Guide 164202123—Rev 1 37DIP Switch DescriptionDIP switch definitions for the PXGX UPS Card are listed in Table 5.Open AlarmsAlarm notices display in three areas of the Web interface:l Banner: If there is an active alarm(s) present on the UPS (Condition Active: true), a flashing alarm icon andan alarm message display in the banner. The alarm icon and message reflect the actual condition of thehighest active alarm in the UPS. Clicking the alarm message displays the Open Alarms page.l Device Data Summary and List page: If there is an open alarm(s), the “(Alarms Present)” messagedisplays at the top of the Device Data Summary and List page and the alarmed data value(s) is highlighted inred text and continues to display in the alarm state until the alarm is closed.l Menu bar: If there is an open alarm(s), “Open Alarms” and the number of active alarms display in red underthe Alarms menu. Clicking Open Alarms displays the Open Alarms page.Table 4. Stacked Indicator DescriptionsLabel Color Illuminated Not IlluminatedStatus Green Communication with the UPS has beenestablished.Communication with the UPS has not beenestablished. As the card boots, the indicator remainsoff. However, if it remains off after two minutes,there is a communication problem between the cardand the UPS.DHCP Amber The PXGX UPS Card is configured for DHCPand has obtained IP address information.The use of DHCP has been disabled by the user, orPXGX UPS Card has failed to obtain IP addressinformation.Ident Red A firmware update is in progress. Do notremove the card from the UPS.A firmware update is not in progress.Power Green DC power is available to the card from theUPS.If all indicators are not illuminated, DC power is notavailable from the UPS. This may indicate that theUPS is off and unplugged.Note: During the power-on sequence, all four indicators illuminate briefly. Wait at least two minutes for thecard's boot process to complete before comparing the indicators to the table above becauseindicators may turn on and off at different times in the boot process.Table 5. DIP Switch DefinitionsS1 Position Number OFF Position (Default) ON Position1 Enable previously stored networkconfiguration settings (Normal mode)Override the existing network settings and assign the local IP address169.254.1.1.2 Reserved Reserved.3 Normal behavior Reset the HTTP passwords to the defaults on boot (user and admin).After a successful boot, the switch should be turned back off beforerebooting the card.4 Reserved Reserved.5 Reserved Reserved.6 Normal behavior Reset the card to factory defaults on boot (after a successful boot, theswitch should be turned back off before rebooting the card again).