Eaton Powerware 9395 Installation And Operation Manual

Also see for Powerware 9395: Mechanical Installation Manual Installation instructions Installation and operation manual Installation and operation manual Installation instructions and operators manual

Contents

UPS SYSTEM INSTALLATIONEATON Powerware® 9395 UPS (450–550 kVA) Installation and Operation Manual 164201701 Rev 2 www.powerware.com4−244.7.3 X−Slot ConnectionsNOTE LAN and telephone drops for use with X−Slot cards must be provided by the customer.NOTE When installing external wiring to X−Slot cards, conduit must be installed to the UPS cabinet. Wheninstalling internal wiring to X−Slot terminals, route the wiring through the internal opening in the X−Slotcommunication bay.For installation and setup of an X−Slot card, contact an Eaton service representative(see page 1−10).To install wiring to connections:1. If not already installed, install the LAN and telephone drops.2. Unfasten the front door latch and swing the door open (see Figure 4-2 onpage 4−4).3. Remove the UPS cabinet interface entry conduit landing plates to drill or punchholes (see Figure 4-3 on page 4−7).4. Reinstall the interface entry plates and install the conduit.5. Route and install the LAN, telephone, and other cables to the appropriate X−Slotcards. See Figure 4-12 on page 4−18 and Figure 4-18 for X−Slot communicationbay locations.6. Close the front door and secure the latch.7. Refer to the manual supplied with the X−Slot card for operator instructions.X−Slot Communication Bay 1 X−Slot Communication Bay 2X−Slot Communication Bay 3 X−Slot Communication Bay 4Figure 4-18. X−Slot Communication Bays