Eaton Powerware BladeUPS none User Manual

Also see for BladeUPS none: User guide User guide Installation guide User guide User guide

Contents

MAINTENANCEEATON Powerware® BladeUPS® EBM User's Guide 164201650 Rev 2 www.powerware.com 25C A U T I O NThe EBM is heavy [77 kg (170 lb)]. A minimum of two people are required to lift the cabinetinto the rack.To replace the EBMs:1. Switch all battery circuit breakers to the OFF (O) position (seeFigure 9 on page 21).2. Unplug the EBM cable from the UPS.If additional EBMs are installed, unplug the EBM cable from thebattery connector on each EBM.3. If not already installed, install the supplied mounting brackets on thenew EBM.4. Replace the EBM. See the following section, “Recycling the UsedBattery or UPS,” for proper disposal.5. Plug the EBM cable(s) into the battery connector(s) as shown inFigure 9 on page 21.6. Remove the breaker tie from the circuit breaker on all EBMs.7. Switch all battery circuit breakers to the ON ( | ) position.

/ 32

Related manuals for Eaton BladeUPS none