Eaton RM3-400-0330 Installation And Operation Manual

Contents

System ControllerCopyright © 2007-2010 Eaton Corporation. All Rights Reserved.IPN 997-00012-62E June 2010 393 Connect a USB A/B cable from a USB port on the PC/laptop to the USB port on the SC200. See the diagram on page 5 for location of the USB port.4 DCTools will now connect to the SC200. If connection is not successful refer to DCTools Help (press F1) or Troubleshooting on page44.5 For details of the SC200 control and monitoring functions available via DCTools see SystemOperation in the System Controller Operation Handbook. For help using DCTools press F1.Using DCTools via RS232DCTools can be run on a PC/laptop connected to the SC200 or SC100's RS232 port. For remote PC/laptop connection details see Communications Options in the System ControllerOperation Handbook.Before you start you will need:• The latest version of DCTools available from: www.powerquality.eaton.com/downloads.• A PC/laptop with RS232 port and DB9 F/F Null-modem cable (RadioShack 55010600,Jaycar WC7513, or similar. Cross-over connections: 5-5, 2-3, 3-2.)► To connect a PC/laptop to the SC200 or SC100:1 Download the latest version of DCTools from: www.powerquality.eaton.com/downloads.2 Install DCTools on the PC/laptop.3 Connect a null-modem cable from the COM1 RS232 port on the PC/laptop to the RS232connector on the SC200 or SC100. Ensure the cable is secured so that no force is applied to the RS232 connector as this maydamage the connector. If COM1 port is not available or for more details see Direct RS232 Communications in theSystem Controller Operation Handbook.4 Start DCTools to open the Connection List. Check the box for the COM1 connection.5 DCTools will now connect to the SC200 or SC100. If connection is not successful refer to DCTools help (press F1) or Troubleshooting on page44.