Eaton XV-102 Operating Instructions Manual

Also see for XV-102 Series: Instruction leaflet Operating instructions Instruction leaflet Quick start guide Manual

5 Installation5.4 Mounting46 XV-102 Micro Panel MN04802004Z-EN—February 2013 www.eaton.com5.4 Mounting1 Check the device for damage in transit.2 Mount the device in the control cabinet, control panel or the control desk. See Chapter 5.4.1Mounting the device, 47.3 Connect the device as required. Follow the instructions on wiring the relevant interface. See Chapter 5.3 Interfaces, 23.CAUTIONOperational malfunctionsUse of unsuitable or improperly prepared cables, as well as incorrect wiring willmean that neither the values stated in the technical data nor the electromagneticcompatibility (EMC) can be ensured.X Only use cables prepared by specialists.X The cables used must be prepared according to the interface description in thisdocument.X The wiring instructions for the relevant interface must be observed when wiringthe device.X Any generally applicable regulations and standards must be fulfilled.CAUTIONDevice condensationIf the device is or was exposed to climatic changes (temperature fluctuation, air hu-midity) moisture can form on or in the device (device condensation). In this case,there is a risk of short-circuit.X The device must not be switched on when device condensation is present.X If condensation is present on the device, or if it was exposed to temperature fluc-tuations, it must be allowed to adjust to room temperature (do not expose the de-vice to the direct heat of heating devices) prior to commissioning.) The device must only be installed and commissioned in perfect technical condition andin compliance with this document.) The device is not provided with an On/Off switch. If the power supply is not providedwith a switch, the device will start up (boot) as soon as it is connected to the power sup-ply.www.comoso.com