Eaton gree motion xChargeIn DC 22 Installation Manual

30 XCHARGEIN DC 22 INSTALLATION MANUAL MN192004EN September 2021 www.eaton.com00 Title7.2.1 Configure an online station via LAN networkThe router of the EV charging station is usually preconfigured. Final steps are required during the installation. Contactyour Eaton service representative for further details.Follow the steps below to configure the router of the unit for connection via LAN network:Step 1. Connect your laptop with one of the LAN ports of the router via an ethernet cable. See Figure 27.Figure 27. Teltonika RUTX09 modem/routerNumber Description1 WAN Ethernet port2 LAN Ethernet ports3 SIM card slotStep 2. Ensure the laptop is below the same subnet of the RUTX09 router. The default IP address of the router is192.168.52.1. Contact your Eaton service representative for further details for the router credential.Step 3. Connect to the router. If a step-by-step configuration menu "Setup Wizard" appears, ignore it and go directly tothe menus described below.Step 4. Go to the Network> WAN menu.Step 5. Activate the WAN network and deactivate the other networks.Step 6. Press Save & Apply.Step 7. Authorize the management of the router from the WAN (Only in a private network).Go to System> Administration> Access control.Step 8. Check Enable Remote HTTP and Enable Remote HTTPS.Step 9. Connect the WAN ethernet port of the Teltonika RUTX09 router via an ethernet cable to a local modem.The ethernet cable can be routed through the dedicated opening on the bottom-left or rear-left side of thexChargeIn DC 22. See Figure 20.2 13