Eaton xChargeIn Mobility User Manual

9XCHARGEIN MOBILITY USER MANUAL MN191006EN March 2021 www.eaton.com4. How to start and stop chargingElectrical systems or devices must be checked by the installer of the system before commissioning andswitching on the unit for the first time.Follow these steps to charge:1. Check that the display indicator of the xChargeIn Mobility is a green car icon. This means that the charging station isready for use. See section 5 on Display Indicators as references.2. If the charging station is equipped with a RFID reader, place the RFID card close to the reader to authenticate yourself.Figure 3. Where to place the RFID card on the xChargeIn Mobility for user authenticationIf the card is recognized, the charging station display shows a blue battery icon. See section 5 on Display Indicators asreferences.If the card is not authorized, the charge will not start, and a red triangle is displayed on the charging station status display.See section 5 on Display Indicators as references.If the charging cable is disconnected from the car and there is no power consumption within two minutes, the user isautomatically deauthenticated.3. Start a charge by connecting the appropriate charging cable of the EV charging station to the car socket. While yourvehicle is charging, the charging station display shows a blue battery “topping up”. See section 5 on Display Indicatorsas references.4. When the battery is fully charged, the xChargeIn Mobility display shows the battery in blue fully charged. See section5 on Display Indicators as references.5. To stop charging, unplug the connector of the charging cable from your vehicle. Usually, the connector must bereleased from inside your vehicle first. Refer to the instruction manual of your vehicle.