Ebyte E32-868T20D User Manual

Also see for E32-400T20S: User manual User manual User manual Manual User manual

Contents

Ebyte E32-868T20D User Manual Manual pdf 17 page image

Chengdu Ebyte Electronic Technology Co,;Ltd E32-868T20D user manualCopyright ©2012–2019，Chengdu Ebyte Electronic Technology Co.,Ltd. 16 Assuming the module is soldered or placed over the Top Layer, it is wrong to randomly route over the Bottom Layeror other layers, which will affect the module's spurs and receiving sensitivity to varying degrees； It is assumed that there are devices with large electromagnetic interference around the module that will greatlyaffect the performance. It is recommended to keep them away from the module according to the strength of theinterference. If necessary, appropriate isolation and shielding can be done； Assume that there are traces with large electromagnetic interference (high-frequency digital, high-frequency analog,power traces) around the module that will greatly affect the performance of the module. It is recommended to stayaway from the module according to the strength of the interference.If necessary, appropriate isolation and shieldingcan be done. If the communication line uses a 5V level, a 1k-5.1k resistor must be connected in series (not recommended, there isstill a risk of damage)； Try to stay away from some physical layers such as TTL protocol at 2.4GHz , for example: USB3.0； The mounting structure of antenna has a great influence on the performance of the module. It is necessary to ensurethat the antenna is exposed, preferably vertically upward. When the module is mounted inside the case, use a goodantenna extension cable to extend the antenna to the outside； The antenna must not be installed inside the metal case, which will cause the transmission distance to be greatlyweakened.9 FAQ9.1 Communication range is too short The communication distance will be affected when obstacle exists. Data lose rate will be affected by temperature, humidity and co-channel interference. The ground will absorb and reflect wireless radio wave, so the performance will be poor when testing near ground. Sea water has great ability in absorbing wireless radio wave, so performance will be poor when testing near the sea. The signal will be affected when the antenna is near metal object or put in a metal case. Power register was set incorrectly, air data rate is set as too high (the higher the air data rate, the shorter thedistance). The power supply low voltage under room temperature is lower than 2.5V, the lower the voltage, the lower thetransmitting power. Due to antenna quality or poor matching between antenna and module.9.2 Module is easy to damage Please check the power supply to ensure that it is between the recommended power supply voltage. If the maximumvalue is exceeded, the module will be permanently damaged. Please check the stability of power source, the voltage cannot fluctuate too much. Please make sure antistatic measure are taken when installing and using, high frequency devices have electrostaticsusceptibility.

/ 20

Related manuals for Ebyte E32-400T20S