Echo 99944200600 Operator's Manual

Contents

PAS 80 TooTh BlAde Trimmer ATTAchmenToPerATor'S mAnuAl9Install Metal Shield1. Loosely attach bracket (A) to shield (B) and attach to bottom ofgear housing (C) with screws and nuts provided. Tighten allhardware.blade InsTallaTIonInstall Blade2. Install upper plate (D) on splined PTO shaft. Blade installationrequires use of Upper Plate (D) with 20mm pilot.3. Place Blade (E) over upper plate pilot, install the Lower Plate (F)and 10mm LH nut (G).4. Insert Locking Tool (K) through hole in upper plate and notch ingear housing to prevent PTO shaft from turning. Tighten nutand secure with Split Pin (L).BLADE UPPER PLATEDInsTall handle /barrIer barNOTEThe Barrier Bar is required when using grass or weed blades. Unitsequipped with U-Handles do not require installation of the BarrierBar.1. Remove screws and nuts and back plate from handle.4-screw front handles2. Position front handle on shaft and install Barrier Bar using four (4)5x35 mm screws and (4) new nuts included with kit. Handle mustbe at least 10 inches (250 mm) from center of rear handle grip.3. Adjust handle position for comfortable operation, and tightenscrews securely.2-screw front handles2. Position front handle on shaft and install Barrier Bar using two(2) 5x35 mm screws provided in kit. Handle must be at least 10inches (250 mm) from center of rear handle grip.3. Adjust handle position for comfortable operation, and tightenscrews securely.NOTEThe Barrier Bar is not a handle.