Echo CS-3000 TYPE 1E Instruction Manual

Also see for CS-3000 TYPE 1E: Operator's manual Parts catalog Operator's manual Operator's manual Operator's manual

Contents

Echo CS-3000 TYPE 1E Instruction Manual Manual pdf 10 page image

10KickbackGENERALCUTTING INSTRUCTIONS[NOTE]Read the ECHO “CHAIN SAW SAFETY MANUAL” included withyour chain saw for additional cutting and safety instructions.In all circumstances the operation of the chain saw is a one-man job. It is difficult at times to take care for your own safety,so don’t assume the responsibility for a helper as well. Afteryou have learned the basic techniques of using the saw, yourbest aid will be your own good common sense...The accepted way to hold the saw is to stand to the left of thesaw with your left hand on the front handlebar and your righthand on the rear handle so you can operate the throttle triggerwith your right index finger.Before attempting to fell a tree, cut some small logs or limbs.Become thoroughly familiar with the controls and the re-sponses of the saw.Start the engine, see that it is running properly. Squeeze thetrigger to open the throttle wide open and start the cut. If thechain is properly sharpened, the cutting should be relativelyeffortless. It is not necessary to press down hard to make thesaw cut. Pushing the saw too hard will slow the engine andcutting will actually be more difficult.Some material may adversely affect the housings of yourECHO chain saw.(Example: Palm Tree Acid, fertilizer, etc.) To avoid housingdeterioration, carefully remove all packed saw dust aroundclutch and guide bar area and wash with water.)CAUTIONDo not let the tip of the bar touch anything while the engine isrunning. At cutting speed the chain is moving, at a high rate ofspeed. Should the tip contact a limb or log while the chain ismoving, the tip will be pushed upward with considerable force.This is known as kickback. Avoid it!CAUTIONWear suitable hearing protective device such as ear muffs or earplugs to protect against objectionable or uncomfortable loud noises.