Echo POWER PRUNER 99944200530 Operator's Manual

Contents

POWER PRUNER TM ATTACHMENTOPERATOR 'S MANUAL 7Cut only wood. Avoid striking concrete, metal, wire, or other obstruc-tions which could cause kickback or damage to the saw chain.If the saw chain does strike a foreign object, immediately stop theengine, inspect and repair the Power PrunerTM if necessary.EQUIPMENTBefore operation a complete check of the unit must be performed;• Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.P/N 89016022660124675389DESCRIPTIONLocate this safety decal on your attachment. Make sure the decal is legible and that you understand and follow theinstructions on it. If it cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERINGinstructions for specific information.1. GRIP, FRONT - Cushioned grip for left hand.2. SHAFT DECAL - Contain important safety information that must be followed.3. LOWER DRIVE SHAFT ASSEMBLY - Contains a specially designed liner and the flexible drive shaft.4. CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.5. AUTOMATIC OILER ASSEMBLY - Self oiling. Use high quality, low viscosity, non detergent bar and chain oil.6. SAW CHAIN - 91 VX 9.53mm (3/8 inch) low profile Oregon® saw chain. Runs approximately 609.6 m/min.(2000 ft/min) at full throttle.7. GUIDE BAR - 254 mm (10 inch) Bar8. CUTTING SHOE - Used to capture and stabilize branch while cutting. Place cutting shoe against branch, accelerateand lower saw chain into branch.9. GUIDE BAR COVER - Used to cover guide bar and saw chain during transport and storage. Remove guide bar coverbefore using unit.