Echo PPF-2100 Service Data

Also see for Power Pruner PPF-2100: Operator's manual

Contents

2-2 Checking oil line1. Disconnect oil line from the auto-oiler andremove oil tank from the gear case.2. Connect pressure tester #897803-30130 to theoil line (A) using appropriate connector pipe (B)(recommended outer dia. : 4 - 5 mm).3. Apply pressure approximately 0.01 MPa(0.1 kgf/cm2) (1.5 psi). Pressure should not drop.If the pressure drops, leakage may be occurring atoil cap, oil cap O-ring, oil tank, oil line, grommet,or oil tank check valve. Check them and replacedefective part(s).2-3 Checking oil filter and check valve1. Pry out oil pipe grommet (A), and pull out oilline and oil filter (B).2. Wash oil filter in suitable clean solvent orreplace the filter with a new one if damaged.3. Remove oil tank check valve (C), and clean it.4. Check if the valve lips (D) are hardened or leftopened. Replace as required.5. Insert oil tank check valve until flush with oiltank.2-4 Replacing oil line and grommet1. Remove defective oil line and the grommet.2. Insert new oil line to the grommet as shown.(A): 50 mm (2 in)NOTE: Apply an adhesive (Loctite #424 orequivalent) at the grommet.3. Connect oil filter to oil line.9PPF-2100 PPT-2100PPT-2400 PPFD-2400 SERVICE PROCEDURE(A)(B)(A)(A)(B)(C)(D)

/ 12

Related manuals for Echo Power Pruner PPF-2100