14STORAGE1. Clean ProSweep attachment bristles with water.IMPORTANTDo not immerse this attachment in water. Water will enter gearhousing and damage gears, bearings and seals.2. Apply thin coating of oil to metal parts to prevent rust.3. Lubricate lower shaft assembly with grease. (Refer to Lubricationinstructions.)4. Store ProSweep attachment in a dry place out of reach of children.Do not store attachment with the weight resting on brushes whichcould bend over a long period of time. Store attachment with lowershaft housing in a horizontal or vertical position to prevent greaseloss from open shaft end.Storage Hook Installation5. Insert small end of hook into locating hole on attachment shaft.6. Slide plastic cap onto end of attachment shaft.SPECIFICATIONSProSweep Attachment : Approved for use on PAS and Split Boom ModelsAttachment Length ---------------------------------------- 927 mm (36.5 in.)Attachment Width ----------------------------------------- 597 mm (23.5 in.)Attachment Height ---------------------------------------- 279 mm 11 in.)Weight ------------------------------------------------------ 5.1 kg. (11.25 lb.)Drive Shaft -------------------------------------------------- 6.35 mm (0.25 in.)Rotating Direction ----------------------------------------- Towards the operators viewed from the rearBrushes ----------------------------------------------------- Standard 0.7 mm (0.028 in.) Nylon Bristles Optional 0.5 mm(0.018 in.) Nylon BristlesMax Sweeping Width ------------------------------------- 571 mm (22.5 in.)Lubrication -------------------------------------------------- Lithium Base GreaseGear Reduction Ratio -------------------------------------- 40 : 1Sweeper Operating (RPM) -------------------------------- 200Engine Wide Open Throttle (RPM) w/attachment ----- 7700-8500