Echo SMR-2410 TYPE 1E - 02-99 Operator's Manual

Echo SMR-2410 TYPE 1E - 02-99 Operator's Manual Manual pdf 31 page image

GRASS TRIMMER/BRUSH CUTTEROPERATOR' S M ANUAL 31NYLON LINE REPLACEMENTLevel 1.Tools Required: Head locking tool (if head is to be removed)Parts Required: ECHO 0.095" Nylon Trimmer Line 40 feet (12m) long.1. Hold drum (A) and turn spool (B) CW (clockwise) until it stops.Pull spool from drum. DO NOT push in on spool when turning.2. Use one piece of new nylon line (C) 40 ft. (12m) long and threadthrough the molded loop (D) on the spool. Pull line tight andadjust so one end is 6 in. (15 cm) longer than the other.3. Hold the spool, opening toward you. Place index finger betweenthe two strands and wind line, tightly and evenly, in direction ofarrow marked "CC".4. Stop when approximately 6" - 8" (15-20 cm) line (C) remains andplace ends of line in notches (E) in spool (B).5. Feed ends of line through housing eyelets (F) and place spool (B)over drive (G). Align pegs (H) on drive with notches in spool andpush spool into drum.6. Pull on both lines until they come free from notches (E) in spool.7. Hold drum (A) firmly and turn spool (B) CCW (counterclockwise)until it stops. DO NOT push in on spool when turning.8. Pull both lines out and trim to cut-off knife length.