Echo SRM - 2100SB Operator's Manual

Also see for SRM - 2400SB: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Echo SRM - 2100SB Operator's Manual Manual pdf 22 page image

22All ModelsThe starting procedures is the same as Cold Start except DO NOT closethe choke.WARNING DANGERThe cutting attachment should not rotate at idle. If cutting attach-ment moves, readjust carburetor according to "Carburetor Adjust-ment" instructions in this manual or see your ECHO Dealer,otherwise serious personal injury may result.1. Stop Switch - Start/Run. Move stop switch button (A) forward awayfrom the STOP position.2. Primer - Pump Bulb. Pump primer bulb (C) until fuel is visible in the"Clear" fuel return line.SRM-2100SB4A. StartLay the trimmer on a flat clear area. Firmly grasp rear handle gripand throttle lockout with left hand and fully depress throttletrigger to wide open position. Rapidly pull recoil starter handle/rope (D) until engine fires (or maximum five [5] pulls).5A. After engine fires (or five [5] pulls), move choke to “Run” posi-tion. Hold throttle trigger fully depressed and pull recoil starterhandle/rope (D) until engine starts and runs. Release throttletrigger and allow unit to warm up at idle for several minutes.SRM-2400SB4B. Start - Pull Rope.Lay the trimmer on a flat clear area and pull the recoil starterhandle (D) until engine fires.5B. Open Choke - Run.Move the choke to the OPEN - RUN position. Restart engine ifnecessary and allow to warm up running at idle for severalminutes.All ModelsNOTEIf engine does not start with choke in “Run” position after 5 pulls,repeat instructions 4 (A/B) and 5 (A/B).6. After engine warm up, gradually depress throttle trigger to increaseengine RPM to operating speed.STARTING WARM ENGINESRM-2400SBDSRM-2100SBCDA