Echo SRM-210i Operator's Manual
Also see for SRM-210i: Operator's manual
                                  | |
Contents
| 
G RASS TRIMMER /BRUSH C UTTEROPERATOR 'S MANUAL 13NYLON LINE HEAD INSTALLATION1. Align hole in upper plate with notch in edge of gear housing andinsert head locking tool (C).2. Be sure upper plate (A) remains on PTO shaft.3. Place line head onto PTO shaft. Followed by large metal washer.4. Thread L.H. nut on PTO shaft. Tighten securely.5. Install new split pin.6. Remove locking tool (C).CANYLON LINE INSTALLATION1. Shut engine off. Lay unit on the ground with head assembly up.2. Remove old nylon line through center recess of head.3. Thread new lines through outside holes (D) in housing until endsmeet in center of recess.NOTEInsert cutting line ends to center of head recess to insure easyremoval of used lines.FRONT HANDLE INSTALLATION1. Position front handle for comfortable operation and secure screws.D D |
Related manuals for Echo SRM-210i
Echo SRM-210 Operator's Manual
Echo SRM-210 Operator's Manual
Echo SRM-210U Operator's Manual
Echo SRM-210U Operator's Manual
Echo SRM-210SB Operator's Manual
Echo SRM-210SB Operator's Manual
Echo SRM-210AE Operator's Manual
Echo SRM-211 Operator's Manual
Echo SRM-211 Operator's Manual
Echo SRM-2100SB Operator's Manual
manualsdatabase
Your AI-powered manual search engine