Echo SRM-230 Operator's Manual
Also see for SRM - 230S: Operator's manualOperator's manualOperator's manualParts catalogOperator's manual
                                    | |
Contents
|
24lubrIcatIonLevel 1.Tools Required: 13 mm Open End Wrench, Screwdriver, Clean Rag.Parts Required: POWER BLENDX TM 8 oz. (P/N 91014) or LithiumBase Grease.Gear Housing1. Clean all loose debris from gear box.2. Remove plug (A) and check level of grease.3. Add grease if necessary, DO NOT over fill.Drive Shaft(SRM-230 Only)1. Loosen two (2) screws (B) and remove center locating screw (C).Pull gear box and shield from drive shaft housing.2. Pull flexible cable from the drive shaft housing, wipe clean andre-coat with a thin coating [15 ml (1/2 oz.)] of grease.3. Slide the flexible cable back in the drive housing. DO NOT getdirt on the flex cable.4. Install the gear housing and shield assembly.IMPORTANTFlat edge of washers (D) must be against drive shaft.(SRM-230S Only)No Lubrication Needed.B CDAB |
Related manuals for Echo SRM - 230S
Echo SRM-230 Operator's Manual
Echo SRM - 230 Operator's Manual
Echo SRM-230 Operator's Manual
Echo SRM - 230 Operator's Manual
Echo SRM-2305 Operator's Manual
Echo SRM-230U Operator's Manual
Echo SRM-2305 Operator's Manual
Echo SRM - 230U Operator's Manual
Echo SRM-2300 Operator's Manual
Echo SRM-2305U Operator's Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine