Echo SRM-2400SB Operator's Manual

Also see for 260SB: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Contents

Echo SRM-2400SB Operator's Manual Manual pdf 9 page image

99944200563 DESCRIPTIONX7702093505 9© 09/2013 ECHO Inc.DESCRIPTIONLocate the safety decal(s) on your unit. Make sure the decal(s) is legible and that you understand and followthe instructions on it. If a decal cannot be read, a new one can be ordered from your ECHO dealer. SeePARTS ORDERING instructions for specific information.1. FLEXIBLE DRIVE CABLE - Cable end fits into drive shaft coupler of Pro Attachment Series or Split Boom models.Lubricate drive cable every 25 hours with high temperature automotive grease.2. FENDER / WHEEL ASSEMBLY - Consists of pre-assembled wheels, wheel bracket, fender and rubber flap. Forbest results, wheels should be adjusted for 13 mm (0.5 in.) ground clearance and are intended to provideoperational stability over uneven ground.3. FENDER / RUBBER FLAP - Provides operator protection against thrown thatch, rocks and other debris. Alwaysinsure that fender and flap are in place and in good condition before operating Pro Thatch Attachment.4. LOWER DRIVE SHAFT ASSEMBLY - Included separately in the carton and must be assembled to the dethatcher/ gear housing assembly. Contains flexible drive cable, outer shaft housing and safety decal.5. DETHATCHER / GEAR HOUSING ASSEMBLY - Right and left reels pre-assembled to gear housing.6. DETHATCHER REELS - Dethatcher reels have 22 tines each and are pre-assembled to the gear housing. Reelsmust be installed properly to prevent side pull.7. GRASS GUIDE - Attached to the dethatcher assembly / gear housing. The guide prevents tines from penetrating todeeply into the ground, which can cause the dethatcher to bounce and give uneven thatch removal.8. TINES - Steel springs with 51 mm (2 in.) fingers. Tines are protected by a plastic cover to prevent thatch and dirtbuildup.1236 547 8Shaft Label