Echo SRM-265 Operator's Manual
Also see for SRM-265: Parts catalog
                                    | |
Contents
|
24A AlubrIcatIonLevel 1.Tools Required: 8 & 13mm Open End Wrench, Screwdriver, CleanRag, Grease GunParts Required: POWER BLENDXTM 8 oz. (P/N 91014) or LithiumBase Grease.Gear Housing1. Clean all loose debris from gear box.2. Remove plug (A) and check level of grease.3. Add grease if necessary. DO NOT over-fill.Drive Shaft(SRM-265 Only)1. Loosen two (2) screws (B) and remove center locating screw (C).Pull gear box and shield from drive shaft housing.2. Pull flexible cable from the drive shaft housing, wipe clean andre-coat with a thin coating [15 ml (1/2 oz.)] of grease.3. Slide the flexible cable back in the drive housing. DO NOT getdirt on the flex cable.4. Install the gear housing and shield assembly.IMPORTANTFlat edge of washers (D) must be against drive shaft.(SRM-265S Only)No Lubrication Needed.BCBD |
Related manuals for Echo SRM-265
Echo SRM - 265U Operator's Manual
Echo SRM-265T Operator's Manual
Echo SRM-2655 Operator's Manual
Echo SRM-261 Operator's Manual
Echo SRM-266 Operator's Manual
Echo SRM-266/S Operator's Manual
Echo SRM-267 Operator's Manual
Echo SRM-265TES Operator's Manual
Echo SRM - 260S Operator's Manual
Echo SRM-266U Operator's Manual
manualsdatabase
Your AI-powered manual search engine