Echo SRM-266U Operator's Manual

Also see for SRM-266U: Operator's manual

22 X7502026204© 04/2014 ECHO Inc.OPERATION SRM-266UStarting Cold EngineThe attachment will operate immediately when the enginestarts, and could result in possible serious injury. Keepmovable parts of the attachment away from objects thatcould become entangled or thrown, and surfaces thatcould cause loss of control.1. Stop SwitchMove stop switch button (A) forward, away from the STOPposition.2. ChokeMove choke lever (B) to Cold Start Position ( ).3. Purge BulbPump purge bulb (C) until fuel is visible and flows freely in theclear fuel tank return line. Pump bulb an additional 4 or 5times.Note: Lightly place knee on drive shaft to stabilize unit duringstarting. Do not apply excessive downward force ordamage to unit can occur.4. Recoil StarterLay the unit on a flat area and keep movable attachment parts clear of all obstacles. Firmly grasp throttlehandle and throttle trigger lockout with left hand and fully depress throttle trigger to wide open position.Rapidly pull recoil starter handle/rope (D) until engine fires (or maximum five [5] pulls).5. ChokeAfter engine fires (or 5 pulls), move choke lever back to Run( ) position. Firmly grasp throttle handle and throttle triggerlockout with left hand and fully depress throttle trigger to wideopen position. Pull recoil starter handle/rope until enginestarts and runs. Release throttle trigger, and allow unit towarm up at idle for several minutes.Note: If engine does not start with choke in “Run” position after5 pulls, repeat instructions 2 - 5.6. Throttle TriggerAfter engine warm-up, grip throttle handle and support handle. Depress the throttle trigger lockout, andgradually depress throttle trigger to increase engine RPM to operating speed.ABCDD