Echo SRM-280 Operator's Manual

Also see for SRM-280: Operator's manual Operator's manual Installation instructions

Echo SRM-280 Operator's Manual Manual pdf 13 page image

SRM-280/S ASSEMBLY© 5/2013 ECHO Inc.X7502310207 13ASSEMBLYPlastic Shield Installation(Nylon line operation)The plastic shield is for use with the Nylon Line Head only. Install Metal Shield when using plastic ormetal blades, or serious injury may result.1. Remove plastic threaded shaft sleeve and adapter plate (C)from PTO shaft (A).2. Place the shield on the bottom of the bearing housingflange.3. Place shield plate (B) on shield, align holes. Install three (3)screws from bottom through plate and shield into gear case.4. Assemble adapter plate (C) onto PTO shaft.Nylon Line Head InstallationWear Gloves or personal injury may result:• Cutoff knife is sharp.• Gearcase and surrounding area may be hot.1. Be sure adapter plate (C) remains on PTO shaft (A).2. Align locking hole in upper plate with notch in edge of gear housing and insert head locking tool (D).3. Thread line head (E) onto shaft by turning itcounter-clockwise until head is tight against adapter plate(C).4. Remove locking tool (D).Semi-automatic nylon line heads must be used only with plasticdebris shield with cut-off knife. Using nylon line heads withmetal debris shield can result in trimmer damage, caused byoperation with excessive line length.Note: Your nylon line head may appear different than nylon line head shown.Parts Required: Plastic Debris Shield, Shield Plate,three (3) 5 x 16 mm screws.Parts Required: Nylon Line Head.ABCDACDE