Ecler NPA2500T User Manual

Also see for NPA2500T: User manual

Ecler NPA2500T User Manual Manual pdf 12 page image

12• ADVANCED menuAmplifier advanced features:o LCD CONTRAST: adjusts the LCD contrast.o FINDER: enables / disables the display backlight flashing, useful to identify a physical unit withits virtual equivalent in EclerNet Manager software (see EclerNet Manager manual for moreinformation).o INFO: shows the amplifier model and firmware version.o NETWORK: allows setting IP address, mask and gateway for the amplifier Ethernet interface(The default port is 2210. You can not change it with local controls, but with EclerNet Managersoftware only).o POWER ON MODE: allows selecting the amplifier behavior at power-up (POWER switch onthe rear panel). The amplifier can start up in STANDBY mode, ON or recover its last statusbefore the last power supply interruption, for example in the event of a mains power recoveryafter a mains power failure (LAST STATE).o RESTORE: allows resetting all amplifier parameters to their default value, except thecumulative operating time (erases passwords, PRESETS, DSP parameters, setup settings,alarms counters and Ethernet network setup).o PASSWORD: allows assigning the amplifier a user or administrator password.• USER: once this password has been set, the unit will request it each time you try touse any control or adjustment in the amplifier setup (on, off, volume adjustment andaccess to menus).• ADMIN (administrator): once this password has been set, only main screen controlscan be used: power on, power off, volume adjustment and muting. To adjust theamplifier setup (access to menus, MENU key) the password is requested.Note: To disable a password you need to rewrite it with a blank one.Most functions described above have their equivalent in EclerNet Manager software. Please refer to theEclerNet Manager software manual for more information.5. CLEANINGThe front panel should not be cleaned with dissolvent or abrasive substances because silk-printing couldbe damaged. To clean it, use a soft cloth slightly wet with water and neutral liquid soap; dry it with a clean cloth. Becareful that water never gets into the amplifier through the holes of the front panel.