2IntroductionFor your safety in using the CD3100Warnings and caution signs, illustrated below, are posted throughout this manual as well as on theCD3100. They show safe and correct ways to handle the product so as to prevent personal injury toyou, others and to avoid property damage.Before reading through the manual, take time to read through and learn the important information listedin this section.Please read all materials such as manuals and warranties that have come with the product.Eclipse will not be liability for unsatisfactory product performance due to failure to follow theseinstructions.This sign indicates a situation in which incorrect handling ordisregard of this sign might result in death or serious personalinjury.This sign indicates a situation in which incorrect handling ordisregard of this sign might result in personal injury or mayresult solely in damage to property.WARNING● Do not modify this system for use other than that specified herein. Also, do not deviatefrom the installation procedures described herein; Eclipse will not be held liable fordamages including, but not limited to serious injury, death or property damage resultingfrom installations that enable unintended operation.● This main unit requires 12V DC and should only be installed in a vehicle with a 12V negativeground electrical system. Any other installation may cause a fire or other severe damageto the main unit and the vehicle.● Never install this main unit where it will interfere with safe operation of the vehicle. Neverblock the drivers' view. Do not install main unit where it may interfere with operation of thebrakes, the steering or any safety main unit, including seat belts and air bags.● Before drilling holes in a vehicle for installation, you must confirm the locations of pipes,tanks, electrical wiring, and other vehicle systems and components to ensure that there willbe no interference or contact. In addition, you must also apply rust prevention and leakprevention measures at the drilling area. Otherwise, fire or electric shock could occur.● When installing main unit do not remove or alter existing vehicle fasteners, including nuts,bolts, screws, clips, and fittings. Never detach, move or alter existing vehicle wiring,including electrical grounds and straps. Alteration of existing vehicle components maymake vehicle unsafe to operate.● Before installation, remove the negative (-) battery terminal to prevent shocks, electricalarcing, fires, and damage to vehicle wiring and the main unit you are installing.● Secure wiring with tape or plastic ties so that wires do not interfere with vehicle operation,including brake pedal, gear shifter and steering. Position wires so that they will not berubbed, abraded, or damaged by moving vehicle components, including power seats.● To avoid main unit and vehicle damage, including fire, never supply power to installed mainunit in a way which will overload the capacity of an existing vehicle circuit. Never leave apower supply wire or connection uninsulated. Always install supplied fuses, circuitbreakers, and relays.WarningCaution
