Eco Air ECO15P Installation And Operation Manual

Also see for ECO15P: Installation and operation manual

Contents

Eco Air ECO15P Installation And Operation Manual Manual pdf 15 page image

DRAINAGEDRAINAGEDRAINAGEDRAINAGEDuring the process of cooling, some water will be extracted from the air into the unit. Most ofthe water will be evaporated by the coil for maximum efficiency. However in very warmtemperature or humid condition, excessive condensation may occur and will require waterdrainage when tank is full. If the tank is full, both of the compressor and motor will stop. The“water full” sign will light ON, also the machine will beep as reminder.To make the cooling work again, please empty the water by one of the following ways:1. Turn off the air conditioner and avoidmoving it when full.2. Position a container (a water tray forexample) underneath the drain hole.3. Remove the drain knob & rubber plugfrom the drain hole and allow the waterto drain out.4. When the container is almost full,replace the rubber plug in the drainhole and empty the water tray.5. Repeat until the unit is emptied.6. Replace the rubber plug and tightenthe drain knob firmly.7. Switch on the unit - the full water orcompressor operating indicator shouldnot be flashing.FIG.19If you wish to operate the unit without the need to empty the water tank, please:• Remove the drain knob andrubber plug and retain for futureuse.• Connect the drain tube suppliedto the water outlet as shown andlocate the other end into a drain. FIG.20- 13 -