FältCom ECII Flex Manual
Also see for ECII Flex: User manual
                                         | |
Contents
| 
Fält Communications 2016 ©162187 Manual Fältcom ECII® Flex V024D 2016-02-23 Page 18 of 41obtained in alarm input 2. The push button in alarm input 1 is filtered. When the signal inalarm input 2 changes to closed the alarm input 1 will be activated and alarm calls are possi-ble. Please note that there is a 30 second override on the alarm input even though it is fil-tered.Setting of alarm input 3 (AUX)This input is of open/closed character and can be used for a filtering signal, technical alarm oran emergency alarm. It is configured as follows:X is either 0 = Normally Open1 = Normally ClosedY is either 0 = Emergency alarm1 = Technical alarm2 = Filtering signalAlarm input 3 is activated as N/O emergency alarm by default, and can be changed by:From keypad: < X > < Y >From phone: 022 < X > < Y > #Function is deactivated with:From keypad:From phone: # 022 #Please view document Flex I/O description for information on what pins to use.6.9 Test of alarm receptionAfter a finished installation Fältcom highly recommends testing the programmed alarm re-ceivers.Test of Alarm Receiver 1When this sequence is programmed the Fältcom ECII® Flex calls Alarm Receiver 1 afterleaving programming mode.From keypad:It is also possible to leave programming mode manually and pressthe alarm button in the lift car and check that the alarm reaches alarmreceiver 1.From phone: 001 #Test of Alarm Receiver 2When this sequence is programmed the Fältcom ECII calls Alarm Receiver 2 after leavingprogramming mode.From keypad: |
Related manuals for FältCom ECII Flex
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine