Figure 11: Chassis grounding studConnecting the chassis grounding stud to the ground terminalYou will need these tools to properly ground the chassis:• Crimping tool• Single ring ground terminal lug• One 2 AWG copper wire long enough to reach from the chassis to the common bonding network (CBN)After the chassis is installed in the rack and before you provide power to the system, you need to connectthe grounding hardware.1. Use a #2 Philips screwdriver to remove the name plate located on the front of the chassis to expose thechassis grounding stud.2. Remove the M6 Keps nut from the stud.3. Use a crimping tool to crimp the 10 AWG copper ground wire to a single ring ground terminal lug.4. Attach the single ring ground terminal lug to the chassis grounding stud.5. Reinstall the M6 Keps nut to the grounding stud.Use 16 to 18 inch-pounds (1.8 to 2.0 Newton-meters) of torque on the M6 Keps nut.6. Connect the ground wire to a common bonding network (CBN).7. Use a #2 Philips screwdriver to reinstall the name plate.About powering the VIPRION 2400 AC platformThe AC platform ships with two power cords that you must use with the installed power supplies to powerthe chassis.Important: Do not install blades or disconnect blades from the chassis before supplying power to thechassis.Important: Do not use any power cords other than those specifically designed for the VIPRION 2400platform.33Platform Guide: VIPRION® 2400
