FALMEC MILANO+ Installation Manual

15ENGLISHDUCTING & EXTRACTION LEVELS(REMOTE MOTORS ONLY)The Flexi ducting is designed to ensure optimum performance for your range-hood. Please follow the installation instructions carefully.Every FALMEC rangehood must be ducted to the external or in-roof motor unitby the use of non-flammable ducting. The rangehood must not be ducted into awall cavity or a ceiling space where a build-up of grease can occur and become apotential fire risk. Ensure the external outlet on the motor unit unit is not coveredand the air flow is not restricted in any way as this may result in reduced perfor-mance. The duct must at all times have a cross sectional surface area equivalentto the hood outlet. The hood outlet has a circular cross section of 200 mm indiameter or an approximate area of 31,400 mm². Do not reduce the duct size atany time and avoid sharp bends. If the duct run is longer than five (5) metres, itmay be necessary to enlarge the duct size to ensure optimum performance. Themanufacturer does not guarantee performance when the duct length is greaterthan five (5) metres.THE RECOMMENDED DUCT LENGTH (INSTALLATION DISTANCE) IS 4 ME-TERS.THE MINIMUM INSTALLATION DISTANCE IS 3 METERS.GENTLE BENDS IN THE DUCTING ARE RECOMMENDED AS IT ASSISTS INMUFFLING NOISE FROM THE EXTERNAL FAN UNIT.SERVICINGThe installation and fitting of the external or in-roof motor should be done insuch a way that will allow the unit to be removed if service is required. Additionalcosts incurred in the removal, such as damage to walls and roofs, are not coveredunder warranty.The external and in-roof motors unit should be checked regularly to ensurethat nothing is obstructing the air flow from the housing. We also recommenda routine inspection of the remote units every 12 months to ensure optimumperformance.As part of ensuring the maximum life cycle of the remote motors it is advised toclean the baffle filters on the rangehood every 4 weeks.These filters are easily removable and dishwasher safe.PART 1: HOOD INSTALLATION GUIDEINTEGRATED HOODS - REMOTE MOTORINTEGRATED HOODModels include MILANO:F3ML60S1, F3ML90S1, F3MLD90S1, F3MLD12S1and GENOVA F3GV12S1WARNINGDIMENSIONS ARE ACCURATE AT THE TIME OF PRINTING, PR KITCHEN &WASHROOM SYSTEMS PTY LTD RESERVES THE RIGHT TO CHANGE SPECI-FICATIONS WITHOUT NOTICE.FOR BUILDING PURPOSES THE UNIT SHOULD BE PROVIDED TO THE CA-BINET MAKER / BUILDER / KITCHEN DESIGNER FOR EXACT MEASURE-MENTS.THE MINIMUM INSTALLATION DISTANCE IS 3 METERS.GENTLE BENDS IN THE DUCTING ARE RECOMMENDED AS IT ASSISTS INMUFFLING NOISE FROM THE EXTERNAL FAN UNIT.SERVICINGThe installation and fitting of the external or in-roof motor should be done insuch a way that will allow the unit to be removed if service is required. Additionalcosts incurred in the removal, such as damage to walls and roofs, are not coveredunder warranty.The external and in-roof motors unit should be checked regularly to ensurethat nothing is obstructing the air flow from the housing. We also recommenda routine inspection of the remote units every 12 months to ensure optimumperformance.As part of ensuring the maximum life cycle of the remote motors it is advised toclean the baffle filters on the rangehood every 4 weeks.These filters are easily removable and dishwasher safe.To Rangehood UnitGentle BendIn Ducting