FALMEC line Instruction Booklet

Also see for line: Installation sheet Instruction booklet Instruction booklet Instructions

Contents

external cleaning

FALMEC line Instruction Booklet Manual pdf 18 page image

18MAINTENANCEBefore cleaning or carrying out maintenance operations, disconnect the equipment by removing the plug or switching off themain switch.Regular maintenance guarantees proper operation and good performance over time.Special attention is to be paid to the metal anti-grease filters and active carbon filters. In fact, frequent cleaning of the filters and their supports en-sures that no grease is accumulated on the hood, which is dangerous and can cause fires.EXTERNAL CLEANINGYou are advised to clean the external surfaces of the hood at least once every 15 days to prevent oily substances and grease from sticking to them.To clean the brushed stainless steel hood, the Manufacturer recommends using "Magic Steel" wipes. Alternatively, it can be cleaned using a dampcloth, slightly moistened with neutral, liquid detergent or denatured alcohol. Finish off cleaning by rinsing well and drying with soft cloths.Do not use too much water next to the push button control panel and lighting devices in order to prevent humidity from reach-ing electronic parts. You must not use detergents containing abrasive, acid or corrosive substances or abrasive cloths: a directconsequence of not complying with these warnings will result in irreversible deterioration of the hood's surface.The Manufacturer declines all responsibility for failure to comply with these instructions.CLEANING OF INTERNAL PARTSIt is forbidden to clean electrical parts, or parts related to the motor inside the hood, with liquids or solvents.Do not use abrasive products. All these operations are to be carried out after having disconnected the equipment from the elec-trical mains power supply.METAL ANTI-GREASE FILTERSThe metal anti-grease filters are there to contain suspended grease particles: deposited on the filters, these feed on anyflames released when cooking, generate unpleasant odours, and compromise the passage of air, thus reducing suctionperformance of the hood.For this reason, it is advised to frequently wash the metal filters (at least once a month) leaving them to soak in boilingwater and dish washing liquid for 1 hour, taking care not to bend them. Do not use corrosive, acid or alkaline detergents.Rinse them well and wait for them to be completely dry before reassembling them.Washing in a dishwasher is permitted, however, it may cause the filter material to darken: to reduce the possibility of thisproblem from happening, use low-temperature washes (55°C max.).Use the handle to take out the metal anti-grease filters (see instructions F on page 6). Carry out operations in reverse order to insertthem.ACTIVE CARBON FILTERSActive carbon filters have the function of retaining odours in the air flow passing through them. The air, purified by runningmany times through the filter, is recirculated into the kitchen. Active carbon filters cannot be washed and are to be imme-diately replaced every 3-4 months (depending on the frequency of use of the hood).Dispose of the active carbon filters in compliance with the regulations in force in the country of use.To change active carbon filters, take out the metal anti-grease filters (see instructions F on page 6) and followthe instructions G on page 6.DISPOSAL AFTER END OF USEFUL LIFEThis symbol on products and/or in accompanying documents means that electrical and electronic products used must not be disposed of with general do-mestic waste. For personal treatment, recovery and recycling, you are kindly asked to take these products to designated waste collection points where theywill be accepted freely. Alternatively, in other countries, it is possible to take products back to the local dealer and purchase a new similar product. Properdisposal of these products contributes to saving valuable resources and avoid potential negative effects on personal health and the environment, whichmay be caused by inappropriate disposal of waste. You are kindly asked to contact your local authorities for further information regarding the designatedwaste collection points nearest to you. Penalties for improper disposal of such waste can be applied in compliance with national regulations.INFORMATION REGARDING DISPOSAL IN EU COUNTRIESThe EU Directive with regard to WEEE has been implemented differently by each nation, therefore, should you wish to dispose of this equipment, we adviseyou to contact the local authorities or the dealer to ask for the correct method of disposal.INFORMATION REGARDING DISPOSAL IN OTHER NON-EU COUNTRIES.This symbol is only valid in the European Union: if you wish to dispose of this product in other countries, we advise you to contact your local authorities ordealer to ask for the proper method of disposal.