FAR KJ 60 Original Instructions Manual

Also see for KJ 60: Original instructions Instructions for use TRANSLATION OF ORIGINAL INSTRUCTIONS Original instructions for use

Contents

FAR KJ 60 Original Instructions Manual Manual pdf 13 page image

13GBKJ 60Revisione - 19 Date 10-2013TOPPING UP THE OIL-DYNAMIC CIRCUITYou need to top up the oil-dynamic circuit after a long period of work, when you note a power loss. Put the riveting tool (DWELLAND NOT FED) in a horizontal position and remove the plug (A), by means of a 5 mm Allen wrench (equipped with the rivetingtool); during this operation, check the oil level in order to avoid any overflowing. Then, slowly pour the oil PANOLIN HLP ISO 32into the bellows container (X) which shall be screwed to its seat on the plug (A). While keeping the riveting tool in a horizontalposition and starting air feeding, push the tensile strength button and make the riveting tool carry out some cycles until airbubbles inside the container (X) stop coming out. This condition indicates that the topping up of the oil has fully been achieved.At this point stop the air feeding and, while keeping the riveting tool in a horizontal position, unscrew and close up the container(X) and the plug (A).WARNING: it is very important to follow the about mentioned instructions and use gloves. If you need to empty fully the hydrauliccircuit, you must put the oil in a suitable container and contact a Company that is authorized to discharge any wasteWARNING! Before disconnecting the compressed air hose, make sure that it is not under pressure!We recommend to use oil PANOLIN HLP ISO 32 DIN 51524-2/HLP or similars.WARNING: Make sure that the oil filler cap(A) is tightened at a torque correspondingto Min. 5 Nm ÷ Max. 8 Nm.AX5 mm.min. 5 Nmmax. 8 NmDISPOSAL OF THE RIVETING TOOLFollow the prescriptions of the national laws for disposing of the riveting tool.After disconnecting the tool from the pneumatic system, disassemble and split all the components accordingto the material: steel, aluminium, plastic material, etc.Then proceed to scrap the materials in accordance with current laws.GB