FDI uEZGUI-EXP-DK User Manual

Contents

FDI uEZGUI-EXP-DK User Manual Manual pdf 4 page image

25. ESD WarningThe uEZGUI-EXP-DK is shipped in a protective anti-static package. The device must not be subjected to high electrostaticpotentials. Damage may occur to the board that will not be covered under warranty. General practice for working withstatic sensitive devices should be followed when working with the uEZGUI-EXP-DK.6. Startup ProcedureTo get started with the uEZGUI-EXP-DK, please connect the 50 pin and 20 pin FFCs to the uEZGUI as shown. The uEZGUI-RX62N-35QT does not support the 20 pin expansion. Take care not to damage the FFCs as they are very fragile.uEZGUI-1788-43WQR with uEZGUI-EXP-DK (revision 1 is shown in this picture)After connecting the cables, connect a 7V-24V DC power supply (minimum of 1A) to the 2.1mm barrel plug P8 on theEXP-DK to power on the unit. With uEZ 2.05 or later, the EXP-DK will be auto-detected and the USB ports, Ethernet,RS232, Audio, and high-speed microSD SD card will be automatically enabled. At this time the high speed microSD card isonly support on LPC1788 uEZGUI units. The out of the box demo does not include the video player. This will need to beenabled inside of the project’s Config_Build.h file.7. Mechanical DetailsThe uEZGUI-EXP-DK has 5 screw mounts that accept #6 size screws. The total board dimensions are 5” x 6”.Each of the 4 corner screw mounts is centered 0.2” away from each side of the board.