FDS FD70CV-M-C-6 Installation And Operation Manual

Contents

FDS FD70CV-M-C-6 Installation And Operation Manual Manual pdf 5 page image

Document Number:MAN – FD70CV-M-C-6Rev:BRevision Date:05/05/2017Page 5 of 13© 2017 FDS Avionics Corp.All Rights Reserved.TECHNICAL SUPPORT470-239-7421 or FDSAvionics.comWiring SuggestionsAll shields should be grounded to the connector at the source, and floating at the display.Avoid routing video wiring parallel to: AC wiring Strobe wiring DC motor supply cables Inverter cabling Or any other potential noise source.Composite WiringRecommended cable for s-video/composite and audio purposes is PIC 75 Ohm Coax,P/N V76261. This is a lightweight, flexible, and low signal loss cable which meets FAAflammability requirements of FAR 23.1359(d), FAR 25.853(a) and FAR 25.869(a)(4).Similar aviation coaxial cable can be used from other vendors, as well.Some aircraft are prone to AC noise - we recommend adding to the composite source a75 Ohm video isolation transformer such as Deerfield Laboratory, Inc. Part No. 162-1(www.deerfieldlab.com, (650) 632-4090). In most cases this should be added to the videooutput of the source.