Faber Clear Installation Manual

Also see for Clear: Installation guide

Faber Clear Installation Manual Manual pdf 10 page image

9 < < < <UK IRL3.3 Flue requirementsThe appliance is of the type C11/C31. The appliance will need to be supplied with theapproved Faber flue pipes and terminal, it is not possible to supply your own. Theminimum effective height of the flue system must be 1 meter.Flue routing:• a horizontal extension with elbows is allowed for a maximum of 4 meters (Clearwith flatburner) or 6 meter (Clear with logburner)• vertical max. 12 meters (without horizontal extensions only)Determine with the help of appendix A, B and C if the desired routing is possible.To establish this you will need to calculate: The effective height (this is the real difference in height between the upper side ofthe appliance and the terminal) The total horizontal extension. This is the total horizontal flue length where:1. each 90-degree bend, which is in the horizontal area, counts for 2 meter2. each 45-degree bend, which is in the horizontal area, counts for 1 meter3. elbows and bends at the transition from horizontal to vertically are not tobe counted4. the wall mounted terminal counts for 1 meter3.4 Flue restrictorIf applicable, in the table of appendix B is also stated the size of a flue restrictor. Thisrestrictor needs to be fitted in the combustion chamber when placing the appliance.Normally the smallest flue restrictor is fitted at production.3.5 Terminal positionVerify if the required terminal position meets the local installation regulations regardingdisturbance, good functioning and ventilation:• The terminal must be located so that the outlet is not obstructed. If the flueterminal is located within 2 meters of a footway path or where people could comeinto contact with it, then a suitable terminal guard must be fitted• Terminals located close to shared walkways, footpaths etc. could be subject tolegal constraints and this should be pointed out to the customer before installation.If in any doubt about flue location advice should be sought from local buildingcontrol, or if appliance-related, from the manufacturer including wherever possiblea dimensioned sketch