444www.factoryfive.com 508-291-3443Raise the back of the body with a jack or blocks until the bottom corner of the license plate recess and thetop corner of the transmission mount are lined up. The rear section of the body needs to be leveled and centered side to side by measuring from thewheel opening in to the shock mount, once it is centered mark down either side of the mountingbracket with a marker or tape.Raise the body up until the bottom edge of the license plate recess is flush with the top edge of thetransmission mount and the mount is centered by the two lines drawn in the previous step.Find the center of the transmission mount then mark a line 2.25” to the right (pass side) of this. This willbe the location of the right side of the latch support.Unpack the Hatch Fastener components (FFR# 26166).Locate the right side of the latch support on the line marked on the transmission mount.Push the latch support against the back side of the hatch latch mount area and clamp the latch supportbracket to the transmission mount.Use a 3/16” drill bit and 3/16” rivets to mount the latch support to the transmission mount.From the back side of the latch support bracket drill two ⅛” holes through the bracket and latch mountarea of the body.From the body side of the latch area, use two ⅛” long rivets to mount the body temporarily until the latchis mounted.Firewall mountingSet the aluminum Firewall Panel (FFR# 25497) in place and push it back against the body.
