Falcon 1000 Deluxe Dual Fuel User's Manual & Installation Instructions

Also see for 1000 Deluxe Dual Fuel: User guide

Falcon 1000 Deluxe Dual Fuel User's Manual & Installation Instructions Manual pdf 26 page image

22INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.Fitting the Stability Bracket or ChainUnless otherwise stated, a cooker using a flexible gasconnector must be secured with a suitable stability device.Suitable stability devices are shown in Fig.7-7, Fig.7-8 andFig.7-9.If you are using a stability chain (Fig.7-7) then the chainshould be kept as short as is practicable and fixed firmly tothe rear of the cooker.If you are using a stability bracket (Fig.7-8 and Fig.7-9), thenadjust the bracket to give the smallest practicable clearancebetween the bracket and the engagement slot in the rear ofthe cooker.Fit the bracket so that it engages as far as possible over thechassis of the cooker.Repositioning the Cooker FollowingConnectionIf you need to move the cooker once it has been connectedthen you need to unplug it and, having gripped under thefascia panel and lifted the front of the cooker slightly(Fig.7-6), you need to check behind the cooker to make surethat the gas hose is not caught.As you progress, make sure that both the electricity cable andgas hose always have sufficient slack to allow the cooker tomove.With a stability chain fitted, release it as you ease the cooker out.Do not forget to refit it when you replace the cooker.When you replace the cooker, again check behind to makesure that the electricity cable and gas hose are not caught ortrapped.Conversion to Another GasIf the appliance is to be converted to another gas do theconversion at this point. See the conversion section of theseinstructions and see the instructions in the conversion kit.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The front feet and rear rollers can be adjusted to level thecooker.To adjust the height of the rear of the cooker, use a 13 mmspanner or socket wrench to turn the adjusting nuts at thefront bottom corners of the cooker.To set the front turn the feet bases to raise or lower.CookerOuter stabilitybracketFloorWall3 mm minTypical wall mountingArtNo.070-0014 - Stability bracket - Wall fittingCookerStability bracketFloor3 mm minTypical floor mountingStability chainFig.7-7Fig.7-8Fig.7-9Typical floor mountingTypical wall mounting