INSTALLATIONCheck the appliance is electrically safe when you have finished.23ArtNo.010-0004 Moving the cookerFig.7-6Fig.7-5Lowering the Two Rear RollersTo adjust the height of the rear of the cooker, first fit a 13 mmspanner or socket wrench onto the hexagonal adjustingnut (Fig.7-5). Rotate the nut – clockwise to raise – counter-clockwise to lower.Make 10 complete (360°) turns clockwise.Make sure you lower BOTH REAR ROLLERS.Completing the MoveUnfold the rear edge of the pack base tray. Open the grilldoor and right-hand oven door so that you can get a goodgrip on the bottom of the fascia panel as you move the oven(Fig.7-6).Carefully push the cooker backwards off the pack base.Remove the pack base tray.Position the cooker close to its final position, leaving justenough space to get behind it.nn DO NOT use the door handles or control knobs tomanoeuvre the cooker.Repositioning the Cooker FollowingConnectionIf you need to move the cooker once it has been connectedthen you need to unplug it and, having gripped under thefascia panel and lifted the front of the cooker slightly(Fig.7-6), you need to check behind the cooker to make surethat the electricity cable is not caught.As you progress, make sure that the electricity cable alwayshas sufficient slack to allow the cooker to move.When you replace the cooker, again check behind to makesure that the electricity cable is not caught or trapped.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The front feet and rear rollers can be adjusted to level thecooker.To adjust the height of the rear of the cooker, use a 13 mmspanner or socket wrench to turn the adjusting nuts at thefront bottom corners of the cooker.To set the front turn the feet bases to raise or lower.