Falcon 1092 CT Dual Fuel User Manual

Also see for 1092 Continental Induction G5: User's guide & installation instructions User's manual & installation and servicing instructions User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

Falcon 1092 CT Dual Fuel User Manual Manual pdf 21 page image

21Englisha) Position and level the appliance.b) Draw a pencil line 68mm from the front edge of thelevelling feet.c) Mark off 300mm from the RH side of the unit to indicatethe centre line for the bracket.d) Remove the unit.e) Mark off 595mm to locate the front edge of the lowerbracket. Fix bracket to floor.f ) Measure the height from floor level to the top edgeof the rear channel. Add 3mm to this dimension andassemble the stability bracket to this height (i.e. fromfloor level to underside of top member)Connecting the SupplyThe Gas supply needs to terminate with a down facingbayonet. The rear cover boxes limit the position of thesupply point.view from the rearA position for gas supply connectorB appliance gas inletBecause the height of the cooker can be adjusted andeach connection is different it is difficult to give precisedimensions. Ideally the house supply bayonet shouldbe in the shaded area shown in the diagram. Althougha 900mm hose can be used, a 1250mm hose will allowslightly more flexibility in the positioning of the bayonetand make moving the cooker easier. The hose should befitted so that both inlet and outlet connections are verticalso that the hose hangs downwards.The hose should be fitted so that both inlet and outletconnections are vertical, so that it hangs downwards in a‘U’ shape.The hose must be compatible with the pressure and typeof gas used.Pressure testingThe gas pressure can be measured at the pressure testpoint on the gas connection block. Turn and light one ofthe hotplate burners.For Natural Gas the pressure should be 20 mbar.For Propane the pressure should be 37 mbar.For Butane the pressure should be 28 mbar.Reassemble burner top, making sure it is reassembled inthe correct way on the burner body.Electrical ConnectionThis appliance must be installed by a qualified electricianto comply with the relevant regulations and also the localelectricity supply company requirements.WARNING: THIS APPLIANCE MUST BE EARTHED.NoteThe cooker must be connected to the correct electricalsupply as stated on the voltage label on the cooker,through a suitable cooker control unit incorporating adouble pole switch having a contact separation of at least3mm in all poles. This cooker must not be connected to anordinary domestic power point.The total electrical load of the appliance is approximately7.2kW. The cable size used should be suitable for this loadand comply with all local requirements.Access to the mains terminal is gained by removing theelectrical terminal cover box on the back panel.Connect the mains cable to the correct terminals for yourelectrical supply type.OrCheck that the links are correctly fitted and thatthe terminal screws are tight.Secure the mains cable using the cable clamp.