Falcon Classic Deluxe 100 Dual Fuel User's Manual & Installation Instructions

Falcon Classic Deluxe 100 Dual Fuel User's Manual & Installation Instructions Manual pdf 28 page image

24INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.Repositioning the Cooker FollowingConnectionIf you need to move the cooker once it has been connectedthen you need to unplug it and, having gripped under thefascia panel and lifted the front of the cooker slightly(Fig.7-6), you need to check behind the cooker to make surethat the gas hose is not caught.As you progress, make sure that both the electricity cable andgas hose always have sufficient slack to allow the cooker tomove.With a stability chain fitted, release it as you ease the cooker out.Do not forget to refit it when you replace the cooker.When you replace the cooker, again check behind to makesure that the electricity cable and gas hose are not caught ortrapped.Conversion to Another GasIf the appliance is to be converted to another gas do theconversion at this point. See the conversion section of theseinstructions.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The front feet and rear rollers can be adjusted to level thecooker.To adjust the height of the rear of the cooker, use a 13 mmspanner or socket wrench to turn the adjusting nuts at thefront bottom corners of the cooker.To set the front turn the feet bases to raise or lower.Fitting the Handles and HandrailRemove the 4 mm Allen screws from the doors (Fig.7-10). Fitthe door handles and secure using the 4 mm screws.nn The handles should be above the fixings.Remove the 4 mm Allen screws from the top corners of thefascia (Fig.7-11). Fit the front handrail in position and secureusing the 4 mm screws.Fitting the SplashbackThe cooker can be installed with or without the suppliedsplashback.To fit the splashback, first remove the two 3 mm fixing screwsand nuts on the rear of the grill flue. Hold the splashback inposition and refit the screws and nuts to secure.ArtNo.215-0026 - Handle gaskets fixedFig.7-10Art No 215-0028 - Handrail fascia fixingsFig.7-11