Falcon Classic User's Manual & Installation Instructions

Also see for Classic: User's guide & installation instructions User guide User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

Falcon Classic User's Manual & Installation Instructions Manual pdf 25 page image

21Glass Fronted Door Panelsnn DO NOT use harsh abrasive cleaners or sharp metalscrapers to clean the oven door glass since they canscratch the surface, which may result in shattering ofthe glass.The oven door front panels can be taken off so that the glasspanels can be cleaned. Move the cooker forward to gainaccess to the sides (see the ‘Moving the Cooker’ section under‘Installation’).Open the oven door slightly and remove the front panelfixing screws from the door sides, two each side (Fig.5-7).Carefully lift off the outer door panel. The inside face of theglass panels can now be cleaned – take care not to disturb orwet the door insulation.Note: If the door is triple glazed then the inner two panels arefixed together and should not be separated. After cleaning,carefully refit the outer door panel and replace the side fixingscrews.Ovens‘Cook & Clean’ PanelsThe main oven has side ‘Cook & Clean’ panels which havebeen coated with a special enamel that partly cleans itself.This does not stop all marks on the lining, but helps to reducethe amount of manual cleaning needed.These panels work better above 200 °C. If you do most of yourcooking below this temperature, occasionally remove thepanels and wipe with a lint free cloth and hot soapy water.The panels should then be dried and replaced and the ovenheated at 200 °C for about one hour. This will make sure thatthe panels are working effectively.Removing the Panels to Clean the EnamelInteriorSome of the lining panels can be removed for cleaning.If you wish to clean the enamel interior of the oven, youwill need to remove the shelves before removing the ‘Cook& Clean’ panels. You do not have to remove the supportbrackets to remove the panels. Lift each panel upward andslide forward off the support brackets (Fig.5-8).Once the panels have been removed, the oven enamelinterior can be cleaned.DO NOT use steel wool, oven cleaning pads, or any othermaterials that will scratch the surface.Refit in the reverse order.The Tall OvenTo clean the oven sides, slide out the shelves, unhook thesupports from the oven sides and lift out (Fig.5-9).ArtNo.320-0002a Proplus oven door side screwsFig.5-7Fig.5-8ArtNo.320-0022 Tall oven side supportFig.5-9