Falcon Classic User's Manual & Installation Instructions

Also see for Classic: User's guide & installation instructions User guide User's guide & installation instructions User's guide & installation instructions User's guide & installation instructions

Falcon Classic User's Manual & Installation Instructions Manual pdf 39 page image

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity and gas before servicing. Check appliance is safe when you have finished.35ABCArtNo.311-0010 InjectorsA – Jet, B – Internal injector, C – External injectorArtNo.0102-0011 - Screwingthe control valve bypass screwArt No 215-0028 - Handrail fascia fixingsConversion from Natural Gas (1.0 kPa)to LPG X Propane (2.54 kPa)nn A suitably competent person must perform theconversion. After conversion the installation mustcomply with the relevant regulations and also thelocal electricity supply company requirements. Readthe instructions before converting this appliance.nn Failure to convert the appliance correctly couldinvalidate any warranty or liability claims and leadto prosecution.nn When servicing or replacing gas-carryingcomponents disconnect from the gas supply beforestarting operation. Check the appliance is gas soundafter completion.nn DO NOT use reconditioned or unauthorised gascontrols.nn Disconnect from the electricity and gas supplybefore servicing.nn Before electrical reconnection, check that theappliance is electrically safe.InjectorsRemove the burner caps and heads. Remove the old jets(Fig. 10.1). Fit the new jets (see the ‘Technical Data’ sectionat the back of this book for the correct jets). Reassemble inreverse order.Tap AdjustmentRemoving the Control Panel (depending on model)Remove the handrail. Now remove the 2 cross-headed screwshidden behind the handrail end brackets (Fig. 10.2).Pull off all the control knobs and remove the fixing screwsunderneath the control panel.Lift the control panel and pull forwards, taking care not todamage or strain the wiring.Bypass Screw AdjustmentTurn the bypass screw on each control clockwise to the stop(Fig. 10.3). Refit the control panel.10. Conversion to LP GasFig. 10.1Fig. 10.2Fig. 10.3