Falcon Classic toledo 110 dual fuel User's Manual & Installation Instructions

Also see for Classic 110 Dual Fuel: User guide & installation & service instructions User guide & installation & service instructions User guide User's guide & installation instructions User's guide & installation instructions

Falcon Classic toledo 110 dual fuel User's Manual & Installation Instructions Manual pdf 28 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.26Electrical ConnectionThis appliance must be installed by a qualified electricianto comply with the relevant regulations(AS/NZS 60335.2.6) and also the local electricity supplycompany requirements.Make sure that the mains characteristics (voltage, nominal,power, etc.) match the ratings indicated on the cooker dataplate.Current Operated Earth Leakage BreakersThe combined use of your cooker and other domesticappliances may casue nuisance tripping, so werecommend that the cooker is proctected on an individualRCD (Residual Current Device) or RCBO (Residual CurrentBreaker with Overload)IF IN DOUBT, PLEASE CONTACT A SUITABLY QUALIFIEDELECTRICIAN.The cooker is preset for a single-phase earthed electricalconnection. It is essential to install a multi-pole circuit breakerthat completely disconnects the appliance from the mains,with a minimum contact break distance of 3 mm.nn WARNING: THIS APPLIANCE MUST BE EARTHED.The appliance must be connected to an efficient earthingcircuit. If the electricity network is not equipped with anearth connection, then it must be installed separately incompliance with local regulations.Earthing is a safety measure required by law, and must beperformed with particular care by a qualified technician,who must also check that the electricity supplycharacteristics are correct.The total electrical load of the appliance is approximately7.3 kW. The cable size used should be suitable for this loadand comply with all local requirements.Access to the mains terminal is gained by removing theelectrical terminal cover box on the back panel. Connectthe mains cable to the correct terminals for your electricalsupply type (Fig.7-13 and Fig.7-14). Check that the links arecorrectly fitted and that the terminal screws are tight. Securethe mains cable using the cable clamp.Fixed WiringFor connection to fixed wiring, i.e. flexible conduit, removethe electrical terminal cover box on the back panel. Using thetwo screws, fix the strain relief bracket in position.Fix the conduit-to-conduit mounting bracket onto thestrain relief bracket. Connect the mains cable to the correctterminals for your electrical supply type (Fig.7-15 andFig.7-16). Check that the links are correctly fitted and that theterminal screws are tight.Replace the electric terminal cover box; make sure that theconduit is clear of the bottom flange.ArtNo.132-0001 - 1 phase 240Vac 50Hz1-phase 230 VAC 50 HzFig.7-13ArtNo.132-0003 - Single-phase connections (AUS)A NFig.7-14ArtNo.132-0002 - 3 phase 240/415Vac 50Hz3-phase 240/415 VAC 50 HzFig.7-15ArtNo.132-0004 - Fixed wiring connection (AUS)MainsterminalFixing bracket forconduit connectionConduitCable clampStrain reliefbracketFig.7-163-phase 230 V 50 Hz