WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity before servicing. Check appliance is safe when you have finished.406. Doors6.1 To Remove the Grill DoorRemove the left-hand side panel (see 1.2). Remove thecontrol panel (see 1.1). Remove the centre cover strip (5screws, 2 top, 2 bottom, 1 in middle). Remove the twocountersunk screws (1 each side) securing the grill hinge armsto the front of the grill chamber.Note: The arms are spring tensioned. Carefully remove thegrill door. Retain the gaskets.Reassemble in reverse order, ensuring that the gasket is fittedbetween the hinge arm and the front of the grill chamber.Remove the two screws and washers securing the grillelement front support. Remove the screws from the grillelement. Lift the element out carefully, disconnecting theleads from the element terminals (noting their position). Ifit is not possible to disconnect the leads in this way, pull thecooker forward to gain access to the rear, remove the screwssecuring the electric cover to the back sheet, remove thecover and disconnect the terminals from the rear.Fit the new element and reassemble in reverse order. Checkthe operation of the grill.6.2 To Replace an Oven DoorOpen the oven door. Support the door and remove the twoscrews securing the upper hinge and gasket to the cookerfront (Fig. 10.3). Remove the door from the lower hinge bylifting slightly and moving outwards (Fig. 10.4).nn THE DOOR IS HEAVY, SO TAKE CARE.Reassemble in reverse order.6.3 To Adjust an Oven Door AngleThe bottom hinge of either oven door can be adjusted toalter the angle of the door (Fig. 10.5). Loosen the bottomhinge fixing screws and use the notch and a flat bladedscrewdriver to move the position of the hinge to set thehinge position (Fig. 10.6).Retighten the hinge screws.6.4 To Replace the Main Oven Door Outer PanelMove the cooker forward to gain access to the sides.Open the oven door slightly and remove the front panelfixing screws from the door sides – two each side(Fig. 10.7).Carefully lift off the outer door panel.Remove the door handle from the panel by unscrewing thetwo retaining nuts. Fit the door handle to the new panel. Fitthe panel to the door. Reassemble in reverse order.6.5 To Change the Main Oven Door LatchRemove the outer door panel (see 12). Remove screws ‘B’ thathold the latch assembly to the inner door panel (Fig. 10.8). Fitthe new catch and reassemble in reverse order.Verify the door operation.ArtNo.320-0002a Proplus oven door side screwsArtNo.320-0007 Oven door hinge adjustment 2ArtNo.320-0006 Oven door hinge adjustment 1Effect of hinge adjustment – exagerrated for clarityCentreline of hinge pinOven door omitted for clarityArtNo.320-0001 Door hinges1ArtNo.320-0001 Door hinges2ArtNo.320-0004 Oven door keepArtNo.320-0003 Oven door latchBFig. 10.3 Fig. 10.4Fig. 10.5Fig. 10.6Fig. 10.7Fig. 10.8 Fig. 10.9